Path: utzoo!utgpu!news-server.csri.toronto.edu!clyde.concordia.ca!uunet!samsung!think.com!mintaka!bloom-beacon!eru!luth!sunic!maxim!prc
From: prc@erbe.se (Robert Claeson)
Newsgroups: comp.lang.postscript
Subject: Re: ps/eps, Level II, Error stream
Message-ID: <1749@hugo.erbe.se>
Date: 26 Aug 90 10:56:53 GMT
References: <2782@acorn.co.uk> <1498@chinacat.Unicom.COM>
Organization: ERBE DATA AB, Jarfalla, Sweden
Lines: 13

In a recent article woody@chinacat.Unicom.COM (Woody Baker @ Eagle Signal) writes:

>Under centronics mode, the returned error message go out the 9 pin
>serial port.  Just why they should go out that particular RS-422
>port, is a mystery.  Normally people use the 25 pin port.

Is there any way to change the port the error messages are sent to?

-- 
Robert Claeson                  |Reasonable mailers: rclaeson@erbe.se
ERBE DATA AB                    |      Dumb mailers: rclaeson%erbe.se@sunet.se
                                |  Perverse mailers: rclaeson%erbe.se@encore.com
These opinions reflect my personal views and not those of my employer (ask him).