Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!uunet!munnari.oz.au!evan From: evan@cs.mu.OZ.AU (Evan Harris) Newsgroups: comp.periphs.scsi Subject: Re: Drive not recognised by diag Message-ID: Date: 22 Aug 90 00:07:59 GMT References: <345@decvax.decvax.dec.com.UUCP> Sender: news@cs.mu.oz.au Reply-To: evan@goanna.cs.rmit.OZ.AU Distribution: comp Organization: Computer Science, University of Melbourne, Australia Lines: 27 In-reply-to: tarsa@abyss.zk3.dec.com's message of 21 Aug 90 15:13:09 GMT >>>>> On 21 Aug 90 15:13:09 GMT, tarsa@abyss.zk3.dec.com (Greg Tarsa) said: In article , evan@cs.mu.OZ.AU (Evan Harris) writes: |> We are attempting to install a new Micropolis 1588-15 SCSI drive with |> a Sun 3/60 running SunOS 3.5 via an Emulex MD21 controller. The |> controller already has a SCSI disk and tape drive attached. |> |> The new drive is set to be SCSI unit 1, the Emulex unaltered, however |> diag cannot find the new drive, instead producing: |> Greg> It is not clear to me from your description how your Greg> disk/controller hardware is set up. If the original Greg> diak/tape/controllers work and are in a shoebox and your new Yes. Greg> disk has its own controller is (perhaps) is in another shoebox, No, the new disk does not have its own controller. We want it to be unit #1 on the existing MD21. I assume this is possible? -------------------------------8<------------------------------- Evan Harris evan@goanna.cs.rmit.OZ.AU Dept. of Computer Science ...!uunet!goanna.cs.rmit.OZ.AU!evan RMIT, Australia