Path: utzoo!utgpu!news-server.csri.toronto.edu!mailrus!cs.utexas.edu!sun-barr!ames!dftsrv!amarna.gsfc.nasa.gov!xrtnt
From: xrtnt@amarna.gsfc.nasa.gov (Nigel Tzeng)
Newsgroups: comp.sys.amiga.hardware
Subject: Bernoullis
Message-ID: <3184@dftsrv.gsfc.nasa.gov>
Date: 22 Aug 90 12:47:17 GMT
Sender: news@dftsrv.gsfc.nasa.gov
Reply-To: xrtnt@amarna.gsfc.nasa.gov
Organization: NASA Goddard Space Flight Center - Greenbelt, MD, USA
Lines: 21
News-Software: VAX/VMS VNEWS 1.3-4

There's someone selling a Bernoulli 10+10 (two 10 meg drives) for $275.  Is
this a good price?  Also it is connected by a 37 pin connector.  Is this the
standard external SCSI pinout (I haven't counted the one in back of mine ;-)?  
I'm asking because it is currently sitting off a PC that might be somewhat old.

Other than that I'm curious what drivers I may need (I have the standard
A2000HD set up - 2091A rev 4, 40 MB Quantum, rev 6 motherboard) and if the
stock 2091 software will cover it.  I also recall someone bringing up problems
with bernoullis on the Ami but I wasn't paying attention as I was planning on
getting a syquest drive instead. :-(

Any info is appreciated and time is something of an essence since I have no
idea how long the stuff will be available.  Thanks much!

NT

--------------------------------------------------------------------------------
   // | Nigel Tzeng - STX Inc - NASA/GSFC COBE Project
 \X/  | xrtnt@amarna.gsfc.nasa.gov
      | 
Amiga | Standard Disclaimer Applies:  The opinions expressed are my own.