Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!usc!elroy.jpl.nasa.gov!jato!mona!khioe
From: khioe@mona.Jpl.Nasa.Gov (Kent Hioe)
Newsgroups: comp.sys.att
Subject: KERMIT configuration on 3B1 unixpc
Summary: KERMIT
Keywords: kermit
Message-ID: <4682@jato.Jpl.Nasa.Gov>
Date: 27 Aug 90 22:31:57 GMT
Sender: news@jato.Jpl.Nasa.Gov
Reply-To: khioe@mona.Jpl.Nasa.Gov (Kent Hioe)
Followup-To: khioe@mona.Jpl.Nasa.Gov (Kent Hioe)
Organization: Engineering Analysis Subsystem Environment Group, JPL
Lines: 23


Hi, Does any body know the correct configuration of kermit setup on
ATT 3B1 Unixpc ?

I just installed kermit for 3B1 (from Ohio-state-U's archive). I tried to
run it with the setup:

	 set baud 1200
	 set line internal (also hayes)
     set device /dev/ph1


The above kermit setup did not work when I tried to dial. I got timeout after 
35 seconds later.

Would any one know the correct kermit setup for 3B1 kindly e-mail it to me ?

Thanks for your help.


Kent Hioe
khioe@mona.jpl.nasa.gov   [ 128.149.61.1 ]
elroy!mona.jpl.nasa.gov!khioe