Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!know!zaphod.mps.ohio-state.edu!ub!tksjmi
From: tksjmi@sybil.cs.Buffalo.EDU (JoAnn Illuzzi)
Newsgroups: comp.protocols.tcp-ip.ibmpc
Subject: 2 eth boards, NCSA+ka9q via desqview
Message-ID: <34278@eerie.acsu.Buffalo.EDU>
Date: 30 Aug 90 18:20:11 GMT
Sender: news@acsu.Buffalo.EDU
Organization: State University of New York at Buffalo/Comp Ctr
Lines: 26
Nntp-Posting-Host: sybil.cs.buffalo.edu
Originator: tksjmi@sybil.cs.Buffalo.EDU


 I have an IBM AT using desqview with lots of memory via a fully loaded
 RAMpage.  The machine has 2 3c501s, set at differnet interrupts, 
 dma channels, and io addrs.  

 I want to run NCSA Telnet 2.2tn and ka9q ver 900214NOS together on this
 machine via packet drivers.  I am using ver 5.0 of the 3c501 packet
 driver.  

 I invoke one packet driver at 0x60, another at 0x63, before starting
 up desqview.  They both load ok.  I have set NCSA Telnet's config.tel
 to use 0x60 via 
	ioaddr=60
 and configed ka9q to use 0x63 via
        attach packet 0x63 ec0 3 1500 [128.205.1.13]
 in my AUTOEXEC.NET.

 My problem is that I cannot get NCSA and ka9q to run in separate 
 windows, each using a different packet driver.  The first window opens
 up fine and works, but the second window hangs solid, I have to
 power off the machine.  It doesn't matter if I start ka9q or ncsa
 first, the first window works, the second window hangs. 

 Anyone have any ideas on what might be the problem?
 thanks
 JoAnn