Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!sdd.hp.com!uakari.primate.wisc.edu!uflorida!mephisto!mcnc!unccvax!cs63bld
From: cs63bld@unccvax.uncc.edu (b. daniels)
Newsgroups: comp.sys.atari.st
Subject: Time-out!
Keywords: whats going on with my clocks?
Message-ID: <2663@unccvax.uncc.edu>
Date: 4 Sep 90 20:32:36 GMT
Organization: University of NC at Charlotte
Lines: 18


I have a 1040ST with an ICD HD controller/battery backup clock board.
I am using ICD's non-resident timesetter program and I also have TIMEDRV3
on my system (the corner clock that shows drive access).

Here's the strange part:
After system bootup, the TIMEDRV3 clock shows the correct time, but the time
shown by FLASH, the Control Panel, and that the system writes to files is about
30 seconds behind.

If I reset the clock through the control panel, run the time program to update
the battery backup clock, and reboot, the same situation occurs!

What's going on here?!

Thanks in advance,
Brian
(cs63bld@unccvax.uucp)