Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!samsung!zaphod.mps.ohio-state.edu!sdd.hp.com!hp-pcd!hpfcso!hpfcmgw!hpfcse!hpuflfa!ronw From: ronw@hpuflfa.HP.COM (Ron Williams) Newsgroups: comp.sys.hp Subject: Re: Dialer entry for HP37212B needed. Message-ID: <140013@hpuflfa.HP.COM> Date: 29 Aug 90 15:06:51 GMT References: <306@dynasys.UUCP> Organization: Hewlett-Packard, SSR-Ft. Lauderdale Lines: 58 Try this one... I created It and have used it successfully for a year now. # # hp37212B created by Ron Williams Fri Jun 16 15:51:15 EDT 1989 # # Depress Auto Ans on front panel # # DIP switch settings: # # 1 - D \ # 2 - D > Terminal mode # 3 - D / # 4 - D Primary channel for sending commands # 5 - D \ # 6 - D / 10 bit data: 1 start, 8 data, 1 stop # 7 - D Error correction disabled # + 8 - U \ # + 9 - U / NO flow control # 10 - D \ # + 11 - U / DSR/CTS/CD to RS-232-C definition # + 12 - U DTR behaves to RS-232-C / V.24(108/2) definition # # recommend setting the following internal registers: # (primarily if 'cu' attached for manual dialing) # # 35 = 1 -> local echo in command mode # 36 = 1 -> DEL command line cancelling enabled # 37 = 1 -> backspace (^H) enabled in command mode # 40 = 1 -> enable modem friendly messages # # map % to K (wait for dialtone) # e.g. cu -l culxxx -s -m -dir # # R35=1 # ... # R35? check status of register 35 # ~. get out of cu # # " to K (pause) # # expect "" (nothing) # send pause-for-fraction-of-second c # expect > (greater than prompt) # send D pause-for-fraction-of-second # expect BER? (actually NUMBER?) # send T Cr T for tone dialing # expect LINE (actually ON LINE 1200) # hp37212B =%-" "" \r\p > T\T\r LINE Ron Williams HP Ft. Lauderdale ronw@hpfcse ------------ TEL: T-938-2278 {hpfcse}!hpuflfa!ronw FAX: T-938-2293 COMSYS: 3179 AREA CODE: 305 HPDESK: Ron Williams / HP3179/08