Xref: utzoo comp.sys.dec:3903 comp.unix.ultrix:4359 Path: utzoo!utgpu!news-server.csri.toronto.edu!mailrus!wuarchive!zaphod.mps.ohio-state.edu!mips!apple!motcsd!mcdcup!mcdchg!tellab5!wheaton!stefan From: stefan@wheaton.UUCP (Stefan Brandle ) Newsgroups: comp.sys.dec,comp.unix.ultrix Subject: SCSI Q-Bus controller for DECsystem 5400 with DEC RZ57 Keywords: anybody know how to do it? Message-ID: <2160@wheaton.UUCP> Date: 28 Aug 90 21:02:12 GMT Organization: Wheaton College, Wheaton Il Lines: 33 I've been round & round & round with my vendor. No luck getting the RZ57 on a controller and working. The RZ57 works fine when I connect it to a DECsystem 3100, so it's probably not a problem with the RZ57 (DEC-labelled Micropolis, I believe). The controller card they (Digital Basics) have been pushing is the CMD Technology CMD220/TM (dual disk/tape controller). The second I put it in the 5400, the green LED (all OK) and the red LED (not all OK) both light up and Ultrix does not see the controller when identifying controllers and devices at boot time. Right now I'm just about desperate enough to go with anything that works. I've got the controller to be recognized by Ultrix 3.0 on a VAXstation 3200 (the controller shows up as an MSCP device), but any references to the disk just hang and sit there. Maybe there's something that needs to be switched on the RZ57 to get it working with something other than DECsystem 3100. Anybody have any _WORKING_ solutions to this problem of attaching an RZ57 to a 5400? Lots of brownie points awarded for any working solutions. I'll even give out brownie points for untested solutions. On a related theme, anybody know of _WORKING_ 4mm tape solutions for the 5400? If not, what's your favorite 8mm solution? I'm running Ultrix 3.1C. Thanks, Stefan Brandle -- ---------------------------------------------- MA Bell: (708) 260-4110 --------- Stefan Brandle UUCP: ...!{obdient,uunet!tellab5}!wheaton!stefan Wheaton College or stefan@wheaton.UUCP Wheaton, IL 60187 "But I never claimed to be sane!"