Path: utzoo!censor!geac!torsqnt!news-server.csri.toronto.edu!mailrus!cs.utexas.edu!swrinde!zaphod.mps.ohio-state.edu!brutus.cs.uiuc.edu!julius.cs.uiuc.edu!psuvax1!psuvm!msr113
From: MSR113@psuvm.psu.edu (Matthew Starr Richmond)
Newsgroups: comp.windows.ms
Subject: HIMEM.SYS Questions
Message-ID: <90246.150126MSR113@psuvm.psu.edu>
Date: 3 Sep 90 19:01:26 GMT
Organization: Penn State University
Lines: 17

I don't know if this has been discussed before, so please forgive my
ignorance if it has...
I currently have 2 megs total RAM on an AT 286, and I'd like Windows
3.0 to be able to use all of it.  Now am I correct in assuming that
it must use HIMEM.SYS to do this?  I do install it as a device driver
in CONFIG.SYS, but it says only 64k is used..?  Is there some switch
I can set to make it the whole 2 megs?
On another note, is there a way to draw/create new icons?  Or perhaps
an FTP site where there are some?
Any and all help will be greatly appreciated..
************************************************************************
*     Matthew S. Richmond                                              *
*    __  ______  ,     __    __               MSR113@PSUVM.PSU.EDU     *
*   (      /    /|    /__)  /__)                                       *
*    \    /    /_|   /\    /\               MSR113%PSUVM@PSUVAX1.UUCP  *
*  .__)  /    /  |  /  \  /  \                                         *
************************************************************************