Path: utzoo!utgpu!watserv1!watmath!att!tut.cis.ohio-state.edu!mailrus!accuvax.nwu.edu!nucsrl!telecom-request From: randall@sidd.sandiego.ncr.com (Randall Rathbun) Newsgroups: comp.dcom.telecom Subject: Help Needed With Panasonic KX-T2355 on Rolm System Message-ID: <11917@accuvax.nwu.edu> Date: 7 Sep 90 16:09:10 GMT Sender: news@accuvax.nwu.edu Reply-To: Randall Rathbun Organization: NCR Corporation, Rancho Bernardo Lines: 26 Approved: Telecom@eecs.nwu.edu X-Submissions-To: telecom@eecs.nwu.edu X-Administrivia-To: telecom-request@eecs.nwu.edu X-Telecom-Digest: Volume 10, Issue 632, Message 2 of 12 Has anyone encountered this problem? One of our users plugged their Panasonic KX-T2355 Easa-phone into our Rolm single line phone jack on our Rolm 9000-II CBX system. They called to complain that they couldn't hear anyone. Upon investigation, it appears that the impedance of this phone is too high, causing low volume in the handset. Plugging in the regular Rolm flashphone showed all the hardware functioning normally. We took the Panasonic apart, hoping to find a volume control, but all we saw was a small pot titled VR2. Playing with it made no discernable difference in volume. Has anyone worked with different vendor telephones upon Rolm equipment, and can advise us on what to do? The user wants to keep his autodial buttons, speakerphone capabilities, etc., and really doesn't want to give up his Panasonic phone. Any ideas? Thanks for all suggestions. You may email to randall.rathbun@SanDiego.NCR.COM if you like (no space between San & Diego please). Hope to hear from you! NCR E & M - San Diego | INTERNET - Randall.Rathbun@SanDiego.NCR.COM 16550 W Bernardo Drive | UUCP - {backbone}!ncr-sd!thor!randall San Diego, CA 92127 | TELE # - (USA) (619) 485-3620 or 2358