Path: utzoo!utgpu!news-server.csri.toronto.edu!rutgers!tut.cis.ohio-state.edu!zaphod.mps.ohio-state.edu!van-bc!ubc-cs!uw-beaver!sumax!polari!rwing!nanook
From: nanook@rwing.UUCP (Robert Dinse)
Newsgroups: comp.sys.tandy
Subject: Tandy 6000 floppy
Keywords: init
Message-ID: <144@rwing.UUCP>
Date: 6 Sep 90 05:22:54 GMT
Organization: Totally Unorganized
Lines: 10


     Further investigation:

     Typing "drive" gives nowait and seekrate=118. Setting the drive to
wait and seekrate=0 makes it work again, but it gets reset to these values
at each boot.

     The "drive" command appears to write /xenix, but there is no reference
to either "drive" or /xenix in init. From this I must assume there is some
other method of setting these values (or inadvertentaly randomizing them?)