Path: utzoo!attcan!uunet!munnari.oz.au!uhccux!kahala!bob
From: bob@kahala.soest.hawaii.edu (Bob Cunningham)
Newsgroups: comp.dcom.modems
Subject: T2500/Annex II setup?
Message-ID: <9456@uhccux.uhcc.Hawaii.Edu>
Date: 19 Sep 90 17:20:57 GMT
Sender: news@uhccux.uhcc.Hawaii.Edu
Organization: University of Hawaii
Lines: 39

I'd appreciate advice on the correct way to set up a Telebit T2500
for incoming call use on an Annex II terminal server.

This doesn't quite work (modem goes off hook, but doesn't allow connections):

	RS232 cabling, besides the obvious TX, RX, GND (pins 2, 3, & 7):

		modem				Annex

		8  (DCD)	----		CTS
		20 (DTR)	----		DTR
	
	On the Annex side (everything else defaulted):

		speed			19200
		control_lines		modem_control
		type			cli
		inactivity_timer	60
		term_var		"vt100"
		bidirectional_modem	N
	
	On the T2500 side (everything else defaulted);

		S00=001			(answer 1st ring)
		S51:005			(interface at 19200)
		S52:002			(hard reset when DTR toggles)
		S54:003			(pass thru BREAK)
		S61:255			(speaker volume high)
		S66:001			(lock interface speed [at 19200])

I'm probably overlooking something obvious...but what?


Bob Cunningham
bob@kahala.soest.hawaii.edu
--
Bob Cunningham
School of Ocean & Earth Science & Technology, University of Hawaii
bob@kahala.soest.hawaii.edu