Path: utzoo!attcan!uunet!zephyr.ens.tek.com!uw-beaver!mit-eddie!snorkelwacker!usc!sdd.hp.com!hplabs!hpda!hpcupt1!hprnd!hprpcd!!kenp From: kenp@hprpcd.HP.COM (Ken Pomaranski) Newsgroups: comp.periphs.scsi Subject: Re: HELP unsetting Unit Attention on HP SCSI disk Message-ID: <15450001@hprpcd.HP.COM> Date: 18 Sep 90 17:41:23 GMT References: <1990Sep10.134015.23841@viewlogic.com> Organization: HP Roseville Site Lines: 48 Try disabling the STDR jumper on the hp drive. This should do the trick! This MAY be the jumper block sequence for your drive. I'm not sure: |o|o|o|o|o|o|o|o|o| |o|o|o|o|o|o|o|o|o| -1 0 1 2 3 4 5 6 7 OPTION SETTINGS 0 = Open 1 = Short PIN 1: Reserved PIN 2: Initiate synchronous data xfer request (STDR) 0 = Disable SDTR 1 = Enable SDTR PIN 3: Parity 0 = Parity checking disabled 1 = Parity checking enabled PIN 4: Auto spin up 0 = Drive will NOT spin up until host sends START UNIT command 1 = Drive will automatically spin up on power on PINS 5-7: SCSI address | PINS | Drive address | | 5 6 7 | | | | | | 0 0 0 | 0 | | 0 0 1 | 1 | | 0 1 0 | 2 | | 0 1 1 | 3 | | 1 0 0 | 4 | | 1 0 1 | 5 | | 1 1 0 | 6 | | 1 1 1 | 7 |