Path: utzoo!attcan!uunet!aplcen!uakari.primate.wisc.edu!zaphod.mps.ohio-state.edu!wuarchive!emory!hubcap!mephisto!prism!gt4662b
From: gt4662b@prism.gatech.EDU (BRANHAM,JOSEPH FRANKLIN)
Newsgroups: comp.sys.amiga.hardware
Subject: 86-pin Card edge sought
Keywords: edge
Message-ID: <13578@hydra.gatech.EDU>
Date: 12 Sep 90 17:42:19 GMT
Organization: Georgia Institute of Technology
Lines: 13

Does anyone know a source for an 86-pin card edge? I don't need a connector,
but some way to add a pass through to an Alegra board. 

The Alegra 2M board has some pins which stick out off the back of its
connector. I was hoping to bend the pins and solder them to 1/3 of the edge
and use the other edge for plugging in another toy.

Any suggestions?
-- 
<------------------------------------------------------------------------------>
<  FRANK BRANHAM                      | Currently at work on a VERY deranged   >
<  Georgia Institute of Technology    | RPG. No dice needed. Ever. Nasty       >
<  Internet: gt4662b@prism.gatech.edu | things, worse than hobbitses.          >