Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!swrinde!zaphod.mps.ohio-state.edu!samsung!munnari.oz.au!csc.anu.oz.au!csc3.anu.oz.au!ccadfa!root From: root@maadfa.ma.adfa.oz.au (god) Newsgroups: comp.sys.apollo Subject: Stripe Disk on DN10000 Message-ID: <1910@ccadfa.adfa.oz.au> Date: 20 Sep 90 01:10:20 GMT Sender: news@ccadfa.adfa.oz.au Lines: 47 We are about to stripe two 700 MB disk (with separate disk controller) together. However, we are not sure that the following procedures as defined in /usr/man/cat8/invol.8 is correct, and no one else in local Apollo Support Group can help us with this as they have never done this before. We would appreciate any comments. % invol option: 1 -m Select disk: [w=Winch|s=Storage mod|f=Floppy|q=Quit][ctrl#:][unit#] w0:0 How many disks will you be grouping together? 2 Enter the striping option. 1 (sector stripe) physical volume name: boot_disk Enter remaining members of disk group: Select disk: [w=Winch|s=Storage mod|f=Floppy|q=Quit][ctrl#:][unit#] w1:0 .....invol... } From /usr/man/cat8/invol.8 as shown in the paragraph below, we deduce } the following procedures have to be performed to finally stripe the } two disks as one. } > After you've created a multi-disk set with 1 -m, you must run > invol's option 2 to add logical volumes to the multi-disk set. > Invol will remind you that you must run it with this option. > Specify the primary disk of the multi-disk set (the first disk you > specified) to invol. If you desire a bootable volume, run invol > with option 8, as described above. option: 2 Select disk: [w=Winch|s=Storage mod|f=Floppy|q=Quit][ctrl#:][unit#] w0:0 .....invol... option: 8 Select disk: [w=Winch|s=Storage mod|f=Floppy|q=Quit][ctrl#:][unit#] w0:0 .....Striping Complete..... Many thanks in advance. ------- Patrick Tang Guan Yaw, Phone : +61 6 268 8882 Dept. of Mathematics, EMAIL-ARPA/CSNET : gyp@maadfa.ma.adfa.oz.au ADFA, Canberra, 2600. UUCP : ..!uunet!munnari!maadfa.ma.adfa.oz!gyp AUSTRALIA ACSnet : gyp@ccadfa.cc.adfa.oz