Path: utzoo!attcan!uunet!wuarchive!udel!princeton!phoenix!kadickey
From: kadickey@phoenix.Princeton.EDU (Kent Andrew Dickey)
Newsgroups: comp.sys.apple2
Subject: AppleShare on a //gs
Message-ID: <2603@idunno.Princeton.EDU>
Date: 19 Sep 90 03:16:29 GMT
Sender: news@idunno.Princeton.EDU
Organization: Princeton University, Princeton, New Jersey
Lines: 30

Things aren't looking too good right now.

I used the Installer (yes, the Installer!  The disk was kinda dusty, but
it still went in the drive.  ;-) ) to install Appleshare and Laserwriter
onto my hard drive.  And I can pull both of them up from within the
Control Panel.  However, I get no zones or anything in the boxes for
either of them.  People with Macs in my building say everything works
for them.

I am without my manuals right now, and would appreciate anyone who's set
up //gs's onto an AppleTalk network to contact me.  I remember hearing
that there's a third system disk for the //gs which has networking stuff
on it--where can I get this?

I must be missing something obvious...

Oh yeah, this is how I selected Appletalk--I disconnected my printer
from slot 1 and put my hard drive in the actual physical slot.  I then
set slot 1 to My Card, and slot 7 to Appletalk.  Is this all I need to
do?

Does it matter what version of AppleShare the University is running if I
don't plan to boot off of it?  I know I need version 2.0 of Appleshare
if I plan to boot off of it, but to just USE it, any version is OK,
right?

Any comments are appreciated...solutions would be best, though.  :-)

			Kent Dickey
kadickey@phoenix.Princeton.EDU