Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!uunet!tellab5!wiseman From: wiseman@tellabs.com (Jeff Wiseman) Newsgroups: comp.sys.mac.misc Subject: Re: Re: Disable Call Waiting? (tougher question) Summary: A bandaid Message-ID: <3859@tellab5.tellabs.com> Date: 18 Sep 90 17:49:07 GMT References: <1990Sep14.031451.19329@ecst.csuchico.edu> <6267@bgsuvax.UUCP> Sender: news@Tellabs.COM Organization: Tellabs, Inc. Lisle IL Lines: 40 In article <6267@bgsuvax.UUCP> denbeste@bgsuvax.UUCP (William C. DenBesten) writes: >This would disable call waiting for the host computer's modem line. I'm >sure that the system administrator does not suscribe to call waiting. >The only real solution to this problem would be #3 or #4. Here's something that you might consider. When I'm using my modem I am usually: A) just commanding and watching or B) downloading/uploading "A" is not critical FOR ME. If I get the tone on my phone indicating that a call is coming in, it doesn't do much damage. Wait long enough and the caller figures your unable to answer the phone (a correct assumption since you're already on it :-). "B" is critical but whenever I do it, I do not use streaming. I use a protocol that can handle the bumps (kermit, x,y,z modem, you name it). The real problem is that with nornal defaults on hayes type modems, the tone comming in to signal the call interrupts the carrier that you are communicating with. This causes the modem to (when it sees that the carrier is gone) drop the call. Nasty. Anyone phoning in can interrupt your session. HOWEVER There is a parameter register for the modem (I fergit which one it is off hand..read your manual :-) that you can INCREASE the "carrier missing" delay to (say) 20 or 30 seconds. Now the missing carrier will not result in the session being dropped, only the loss of some data during the incoming tone (ie. "ringing") cycle. This works for me anyway, I supose it depends on your application. Hope this helps -- Jeff Wiseman: ....uunet!tellab5!wiseman OR wiseman@TELLABS.COM