Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!usc!zaphod.mps.ohio-state.edu!van-bc!mplex!fff
From: fff@mplex.UUCP (Fred Fierling)
Newsgroups: comp.protocols.tcp-ip.ibmpc
Subject: ka9q remote command
Keywords: ka9q, remote
Message-ID: <11@mplex.UUCP>
Date: 21 Sep 90 18:47:59 GMT
Organization: Microplex Systems Ltd
Lines: 20

Is there a trick to using the ka9q remote command?  I can't get the remote
to work following the documentation.  Here is the autoexec.net entry on the
remote box:

  start remote -p 2000 -s foobar

Here is my command to reset the remote processor:

  remote -p 2000 -k foobar 128.189.n.n reset

Here is the setup:
 - a couple of IBM AT's
 - 16550 serial ports
 - wd8013 ethernet cards
 - wd8003e.com drivers

Any ideas?
-- 
Fred Fierling       fff@mplex.bc.ca      Tel: 604 875-1461   Fax: 604 875-9029
Microplex Systems Ltd   265 East 1st Avenue   Vancouver, BC   V5T 1A7,  Canada