Path: utzoo!attcan!uunet!know!cs.utexas.edu!usc!julius.cs.uiuc.edu!apple!vsi1!daver!bungi.com!news
From: mea@mea.utu.fi (Matti Aarnio)
Newsgroups: comp.sys.nsc.32k
Subject: Re: Structuring SCSI
Message-ID: <9009261502.AA03080@mea.utu.fi>
Date: 26 Sep 90 15:02:30 GMT
References: <<9009251704.AA10568@manatee.UUCP>>
Sender: news@daver.bungi.com
Lines: 28
Approved: news@daver.bungi.com

> I found the following technique very helpful in trying to structure
> a SCSI device driver, so I thougth I would share it with the group.
> 
> The NCR 53C700 SCSI processor can be programmed in a language they
> call "SCSI SCRIPS".  Since this language is quite device
> independent but SCSI specific, it also makes nice way of expressing
> a psuedo code outline for any SCSI device driver.  If this is of
> interrest call NCR's Information Hot-Line 1-800-525-2252 and ask
> for the NCR-53C700 Programmers Guide and NCR-53C700 Data Manual.
> The Programmers Manual also includes well commented SCSI SCRIP code
> for a sample initiator and target.

  That HOT-LINE is fine for USA, but how about us europeans ?
Could somebody pick up some european contacts ?  Especially if
there is one in Finland ?

  Alternatively, could somebody call them and ask them for
referred data to be sent here ?
(Disclosure of my address is used to arbiter that there is
 only one call.)

..
> Best regards,
> johnc

	/Matti Aarnio <mea@utu.fi>
	University of Turku, Computing Centre
	Turku, Finland