Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!wuarchive!udel!mmdf
From: DPOPE%AUDUCVAX.BITNET@cunyvm.cuny.edu
Newsgroups: comp.sys.amiga
Subject: Quantum 105S Help Needed
Message-ID: <31647@nigel.ee.udel.edu>
Date: 27 Sep 90 03:00:48 GMT
Sender: mmdf@ee.udel.edu
Lines: 23

I have a Quantum ProDrive 105S that I have been trying to connect to my
system.  My configuration:

    A2000
    A2620 w/4 Meg
    A2090 HD Controller
    ASDG Dual Serial Port Board
    ARP 1.3

I also have 2 ST-506 HD's connected and a Seagate ST-277N SCSI HD (as unit 3).
In trying to connect, I have tried various configurations in my mounlist.  I'd
appreciate a setup (surfaces, cylinders, etc.) that will work.  I set the
jumpers on the drive with a jumper on A0, A1 open and a jumper on A2.  I
defined the drive in my mountlist as unit 4.  When prepping, nothing happens.
No light comes on and the drive sits for about 45 seconds before saying
"device not prep'd".  I have tried with a DB-25 to SCSI 50-pin cable and
with a DB-25 to two 50-pin cable.  I get the same results on both.

My BBS is down to about 5 Meg free, so I am getting a little antsy.  Any
help would be greatly appreciated.  Thanks.

Dick Pope
Auburn University