Path: utzoo!attcan!uunet!ogicse!pdxgate!eecs!twells From: twells@eecs.cs.pdx.edu (Tabor Wells) Newsgroups: comp.sys.amiga Subject: Re: Is it possible to change NTSC into PAL? Message-ID: <177@pdxgate.UUCP> Date: 28 Sep 90 07:38:17 GMT References: <29591@nigel.ee.udel.edu> Sender: news@pdxgate.UUCP Lines: 46 boily@phy.ulaval.ca (Edouard Boily) writes: >> Is it possible to change a NTSC-amiga (american version) into PAL? >> And what about the power supply? Can it be changed? (From 60 >> to 50 Hz) >> >> -Frank Tore Johansen > Yes it is possible. **>>On the Amiga 2000<<**, there is an >internal jumper on the power supply that allow you to select the >Amirican or the European standard. Well it isn't just on the 2000. Any Amiga (500's are being shipped w/ the 1 meg Agnus chip) with the 1 meg Agnus chip can switch into PAL mode. Using the program called PALBooter, you can boot as if you were in PAL mode. There is a slight flicker (freq change?), but that is all. > You also have to change two things on your 2000 >motherboard. The Agnus (8361) chip (I don't know about the fat >agnus), and the system clock. NTSC' clock run at 28,63636 MHz and >the PAL' clock run at 28,37516. You do have to change to make sure you have the 1 meg Agnus chip. How do you tell, you ask? Well you should have 1meg of chip ram if you have the fatter Agnus (but not necessarily. I have the chip but 512k chip & 512k fast ram). If you still don't know just try booting PALBooter. You will be able to tell if it works. > You should contack your C= service center for doing the >chip swap. They will inform you about the part numbers of the >cristal and the Agnus(FatAgnus) chips. > Good luck, > Edouard Boily > Dept. de Physique > Universite Laval > Quebec, CANADA +--------------------------------------------------------------------------+ | Tabor Wells | "Wherever you go, there are your | |------------------------------------| kneecaps" | | twells@eecs.cs.pdx.edu | -Pope Anastasius Sixtus Maximus I |