Path: utzoo!attcan!uunet!samsung!zaphod.mps.ohio-state.edu!rpi!leah!bingvaxu!bingsuns.cc.binghamton.edu!consp13
From: consp13@bingsuns.cc.binghamton.edu (Marcus Cannava)
Newsgroups: comp.sys.amiga
Subject: Re: CAD for Amiga, actually much simpler..
Message-ID: <4137@bingvaxu.cc.binghamton.edu>
Date: 2 Oct 90 16:48:31 GMT
References: <30633@nigel.ee.udel.edu| <3187@corpane.UUCP> <12812@sdcc6.ucsd.edu>
Sender: usenet@bingvaxu.cc.binghamton.edu
Reply-To: consp13@bingsuns.cc.binghamton.edu (Marcus Cannava)
Organization: SUNY Binghamton
Lines: 20

To the Net community..

	Lots of discussion has been made about advanced CAD programs for the
Amiga.. I was wondering if there is a program that is simply capable of
line drawings and Ami font support (i.e. for technical diagrams with
nice text) similar to Mac's MacDraw series of programs. 

	CAD programs are close, but I haven't seen one yet that uses fonts
other than those suitable for 'plotting' (i.e. "line fonts"). Plus, none
that I've seen have the gridding (i.e. align to each other, to grid,
etc.) capabilities MacDraw has, either.

				Any suggestions greatly appreciated,

						\marc



'I do not fear computers.. I fear the lack of them'  -- I. Asimov
									RNM