Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!tut.cis.ohio-state.edu!att!linac!midway!galton.uchicago.edu!irwin
From: irwin@galton.uchicago.edu (Mark Irwin)
Newsgroups: comp.sys.mac.apps
Subject: Textures and SuperLaserSpool
Summary: Do they work together?
Message-ID: <1990Oct10.061115.4809@midway.uchicago.edu>
Date: 10 Oct 90 06:11:15 GMT
Sender: irwin@galton.uchicago.edu
Organization: Department of Statistics, University of Chicago
Lines: 38

Does anyone know if Textures 1.2a and SuperLaserSpool 2.02 work together
with a DeskWriter.  When I try to print from Textures with SuperLaserSpool 
active the output is in Geneva.  However when I disable SuperLaserSpool 
either at startup or through the LaserQueue DA I get the right output.  
It appears that when the spooler is active the printer driver doesn't go 
looking for the correct bitmap fonts (they are kept in a folder with the
Textures application as suggested in the manual) but just uses Geneva
instead.

I tried checking to see if other inits were the problem but
SuperLaserSpool was the only one that seemed to cause any trouble.  My
system setup is:

SE/30 4M Ram
System 6.0.5 running under MultiFinder

Init/Cdev active:

Init Cdev 3.0
SAM Intercept 2.0
Boomerang 2.0
CE Toolbox 1.2
DiskTop.Extras
HandOff II 1.0
MacEnvy 2.0
Pyro 4.0
Suitcase II 1.2.6
Sum Shield Init 2.0
SuperClock 3.9
Transform 1.0
Adobe Type Reunion 1.0
WindowShade 1.1
Adobe Type Manager 1.2

If anyone has any ideas I would appreciate hearing from you

Mark Irwin
irwin@galton.uchicago.edu