Xref: utzoo comp.sys.ibm.pc.hardware:2206 comp.sys.ibm.pc.misc:2624
Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!swrinde!zaphod.mps.ohio-state.edu!ncar!midway!quads.uchicago.edu!ace3
From: ace3@quads.uchicago.edu (anibal antonio acero)
Newsgroups: comp.sys.ibm.pc.hardware,comp.sys.ibm.pc.misc
Subject: Logitech mouse programs and Desqview 386: read on
Keywords: mouse,Desqview
Message-ID: <1990Oct13.213136.3869@midway.uchicago.edu>
Date: 13 Oct 90 21:31:36 GMT
Sender: news@midway.uchicago.edu (News Administrator)
Organization: University of Chicago
Lines: 17

I have a Logitech Series 9 serial mouse installed in COM1, and the latest
version of Desqview 386.  In my AUTOEXEC.BAT I load the mouse driver (MOUSE.
COM) and the menu loader (LOGIMENU) into high memory.  At this point all is
well -- I can load any menus I've defined and they work.  When I go into 
Desqview and start up a program (using a batch file which uses LOGIMENU to
load a menu for the program) LOGIMENU says "Mouse driver not found".

Now, I can do without logimenu without too much hardship, and the mouse still
works with programs that recognize it's there (Manifest, Norton Utils, WordPer-
fect, even Desqview!), but I'd like to know what's going on anyhow. 

I welcome any suggestions or advice, especially if you've run into this before
yourself.  If I get any edifying replies I will summarize them in a later
article.  Thanks for your time,

Anibal Acero
acero@quads.uchicago.edu