Xref: utzoo comp.unix.xenix.sco:448 comp.unix.xenix.misc:10 comp.sys.ibm.pc:54471
Path: utzoo!attcan!utgpu!news-server.csri.toronto.edu!rutgers!usc!samsung!rex!uflorida!gatech!mcnc!uvaarpa!murdoch!hopper.cs.Virginia.EDU!fh8n
From: fh8n@hopper.cs.Virginia.EDU (Frank Houston)
Newsgroups: comp.unix.xenix.sco,comp.unix.xenix.misc,comp.sys.ibm.pc
Subject: ST296N SCSI & ST01 controller problems
Message-ID: <1990Oct13.144925.11577@murdoch.acc.Virginia.EDU>
Date: 13 Oct 90 14:49:25 GMT
Sender: news@murdoch.acc.Virginia.EDU
Reply-To: fh8n@hopper.cs.Virginia.EDU (Frank Houston)
Distribution: usa
Organization: University of Virginia Computer Science Department
Lines: 26


	hello netland,

	I am having trouble trying to get my computer to work with
a ST01 hard disk controller and a st296N hard drive. The computer
is a 386/25 clone with 4 megs of ram using CHIPS  & TECHNOLOGIES
chip set. The system boots fine from the hard disk under 
dos 3.3. However, when I boot with an SCO boot disk or Minix,
I get the error. 
					ROM BASIC NOT FOUND
					SYSTEM HALTED

	I have attemped to use my hard drive and controller on a
 northgate super micro system. When I tried the SCO
 unix boot disk , I got the error

					SYSTEM REBOOT

Can the st01 controller work with operating systems other 
   than dos?

	Is there anyone out there who has had similiar problems?

	Any assistance will be greatly appreciated. 

		thanks Frank Houston