Path: utzoo!utgpu!watserv1!watmath!att!att!pacbell.com!ucsd!sdd.hp.com!wuarchive!udel!sbcs!eeserv1!mrose
From: mrose@eeserv1.ic.sunysb.edu (Michael Rose)
Newsgroups: comp.sys.atari.st
Subject: Using MGR and Gulam under MiNT
Message-ID: <1990Oct23.181421.23453@sbcs.sunysb.edu>
Date: 23 Oct 90 18:14:21 GMT
Sender: usenet@sbcs.sunysb.edu (Usenet poster)
Organization: State University of New York at Stony Brook
Lines: 23
Originator: mrose@eeserv1


Hello everyone!

	I sent a post about this a couple of days ago, but it seems 
to have vanished... oh, well...  I was hoping that someone could
please explain how to set up MGR to run under MiNT.  I have gotten it
to run, but I still can't seem to get the icons and different fonts to
work at all.  Could someone post an example MGR.RC file which shows
the proper way of setting up the default paths?  How do you use the 
font program?  Also, I can't seem to get Gulam to work with MGR.  How 
do I get MGR to run the VT52.PRG before it executes Gulam?
	Also, I tried using BGACC with MiNT and it gives me two bombs
when I get the item selector to run a prg in the backround.  I only had
Folder300.prg in the auto folder with MiNT following, and no other prgrams or
accs.  The only other thing that was installed was my hard disk autobooting
driver, the Atari one that came with my Megafile 44.  I am using TOS 1.4.
Does anyone have any suggestions?  Thanks very much!

					Sincerely,

					Michael Rose
-- 
============================================================================