Xref: utzoo comp.sys.ibm.pc.hardware:2505 comp.sys.ibm.pc.misc:2961 comp.sys.mac.misc:4720 alt.sys.sun:1776
Path: utzoo!utdoe!ontmoh!attcan!uunet!munnari.oz.au!mullian.ee.mu.OZ.AU!kklw
From: kklw@mullian.ee.mu.OZ.AU (Kevin K L WONG)
Newsgroups: comp.sys.ibm.pc.hardware,comp.sys.ibm.pc.misc,comp.sys.mac.misc,alt.sys.sun
Subject: Experience in using the SEEQ 8003 ethernet controller
Message-ID: <5866@munnari.oz.au>
Date: 24 Oct 90 17:46:31 GMT
Sender: news@cs.mu.oz.au
Reply-To: kklw@mullian.ee.mu.OZ.AU (Kevin K L WONG)
Organization: Dept. of Electrical Engineering, University of Melbourne
Lines: 13

I am using the SEEQ ethernet chip set to build a ethernet port. From a
logic analyzer, I found that when data is coming in (both CSN and RxD
are active), the 8003 sometimes asserts the RxRDY but sometimes it
doesn't which cause a severe packet loss. I set the Rx command register
as 0x80 (match station address and broadcast) while Tx command register
as 0x00, ie INT is not used at all.

Do I forget to set up anything? Does anyone have experience on this chip
set? Thanks in advance.
 _____________________________________________________________________________
|  Kevin WONG                       |  ACSnet   : kklw@mullian.ee.mu.OZ       |
|  Department of Elec Engineering   |  internet : kklw@mullian.ee.mu.OZ.AU    |
|  University of Melbourne          |  uunet    : uunet!munnari!mullian!kklw  |