Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!swrinde!zaphod.mps.ohio-state.edu!sol.ctr.columbia.edu!ira.uka.de!smurf!artcom0!pf
From: pf@artcom0.north.de (Peter Funk)
Newsgroups: comp.unix.xenix.sco
Subject: Re: SCO XENIX 2.3.2 on i486
Message-ID: <3037@artcom0.north.de>
Date: 2 Nov 90 00:04:15 GMT
References: <18@dhump.lakesys.COM>
Organization: ArtCom GmbH, Atelier f. Computergrafik, Bremen(FRG)
Lines: 39

In <18@dhump.lakesys.COM> 
	mort@dhump.lakesys.COM (Marty Wiedmeyer) asked:

mw> We have SCO XENIX 386 2.3.2 and I have been asked to install it on an 
mw> NCR PC486/MC25.

mw> 1)	Does it run? I know ODT runs, but it's UNIX, not XENIX.

We have succesfully installed SCO Xenix 2.3.2 GT on a number of
Noname-EISA-80486s equipped with 64 MB of RAM.  SCO Xenix 2.3.2
leaves 3/4 of RAM unused. :-)  

But we discovered a serious Problem: Together with a number of device 
drivers the size kernel image grows over the mythical limit of 640 kB.
Also this should be no longer a problem since release 2.3.0 (see pg. 62
on "Large Kernel Support" in Release Notes of 2.3.) we got the following 
error message :

      Not enough physical memory for the kernel!

The board was equipped with an Award BIOS.  On an old 80386/25 
equipped with an American Megatrends BIOS the same kernel boots well.
At the moment, we don't know, whether this is a bios related or 
architecture related problem.  Looks odd: It seems to be necessary
to reverse engineer /boot.... :-(

mw> 	I tried making a bootable disk with mkdev fd and dd'ing N1 to
mw> 	it to no avail.

You will probably also have to patch the minor device numbers of
_rootdev, _pipedev, _swapdev of the floppy kernel image using adb. 
I don't know, whether this is all you need to do, to get the N1-disk
booting.  It may be easier to obtain the 3.5 inch distribution from SCO.
-- 
Peter Funk \\ ArtCom GmbH, Schwachhauser Heerstr. 78, D-2800 Bremen 1
Work at home: Oldenburger Str.86, D-2875 Ganderkesee 1 /+49 4222 6018 (8am-6pm)
>> PLEASE Don't send BIG mails (oversea) ! I've to pay for it : $0.3/kB
   Don't use the bang path of this news article for mails (They will bounce).
   Only the address 'pf@artcom0.north.de' will work. Thank You ! <<