Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!wuarchive!zaphod.mps.ohio-state.edu!uakari.primate.wisc.edu!umriscc!umriscc.tmc.edu
From: fredc@umriscc.tmc.edu (Fred Clauss)
Newsgroups: comp.sys.amiga
Subject: Problems with ARP1.3 relabel and VD0:
Summary: ARP 1.3 relabel won't relabel VD0: from ASDG-RAM: to RAM:
Keywords: VD0, VDK, ARP, RRamDisk
Message-ID: <1590@umriscc.isc.umr.edu>
Date: 1 Nov 90 20:11:26 GMT
Expires: 8 Nov 90 06:00:00 GMT
Sender: news@umriscc.isc.umr.edu
Reply-To: fredc@isc.umr.edu
Organization: University of Missouri - Rolla
Lines: 21

I have recently switched over my workbench to ARP 1.3, and I am having
a bit of a problem, although it is not currently affecting everyday use.
When I got VD0: from a Fish disk some time back, I followed the directions
in the documentation which said to relabel it as RAM: (not knowing why I
should do so).  This worked fine until I switched everything over to ARP.
Now the relabel doesn't seem to work.  For the time being, I just repaired
my startup-sequence to work around not having a RAM: drive (used for T:,
ENV:, and CLIPBOARDS: ), but consider that to be an inferior solution.
Has anyone overcome this problem?  Will I have to go back to the original
relabel command?

While I am on the subject, what is this CleanRamDisk program?  I have yet
to have memory problems since I added 2 meg, but I probably will once I start
writing programs.  Also, is VDK available as shareware?  I also might be
interested in RRamDisk if it isn't too expensive.


-- 
Fred Clauss                  INTERNET:  fredc@isc.umr.edu (preferred)
P.O. Box 815                  		or fredc@ee.umr.edu
Rolla, MO 65401		     BITNET:    S081192@UMRVMA