Path: utzoo!utgpu!news-server.csri.toronto.edu!rutgers!usc!zaphod.mps.ohio-state.edu!mips!daver!bungi.com!news From: dlr@daver.bungi.com (Dave Rand) Newsgroups: comp.sys.nsc.32k Subject: Re: some problems bringing the pc532 up. Message-ID: Date: 4 Nov 90 04:08:53 GMT Sender: news@daver.bungi.com Lines: 33 Approved: news@daver.bungi.com [In the message entitled "some problems bringing the pc532 up." on Nov 4, 3:17, Eyal Lebedinsky writes:] > The machine seems to work. The PI program was downloaded and run with no > problems - but the disk wont respond. You probably have the disk connected to the "Disk/Tape" SCSI port. Surprise! It goes on the connector close to the expansion slots. We haven't put in a driver for the 6250 yet. > > Also, I dont recall seeing a monitor man, was there one? With the built-in help, I've never seen a need for a manual for the monitor... > > The baud command does not affect the rate: I did 'baud 19200' which should > have altered the consol speed but it did not. Try baud d'19200. You are in hex radix mode by default... > Last, J1 and J2 do not have pinput numbers in the layout (I assume 1-2-3 top > to bottom) and no indication which jumper for 1M/4M (I assumed 2-3 for 1M, > 1-2 for 4M). The Theory of Operation manual covers this. Karl's "How I got my PC532 going at 3am" posting convers most of the common stuff, as well. It is in the archives, if you want me to dig it up. -- Dave Rand {pyramid|mips|bct|vsi1}!daver!dlr Internet: dlr@daver.bungi.com