Path: utzoo!attcan!uunet!crdgw1!argentina From: rankins@argentina (raymond r rankins) Newsgroups: comp.sys.apple2 Subject: Re: 5.0.3 & AWGS problem Message-ID: <13674@crdgw1.crd.ge.com> Date: 12 Nov 90 18:39:28 GMT References: <2020@mountn.dec.com> Sender: news@crdgw1.crd.ge.com Reply-To: rankins@argentina (raymond r rankins) Organization: Replace me with your organization Lines: 24 In-reply-to: shatara@islnds.enet.dec.com (Chris Shatara) In article <2020@mountn.dec.com>, shatara@islnds (Chris Shatara) writes: >When I went to print it, I had to use Print SETUP first as the driver had >changed. A curious question. Is this what the Printer.Setup file is for that's in the drivers directory. Is it only there to store that last setup that you used for your printer? I'm curious because I noticed that on the 5.0.3 tools disk, there was a separate *.setup file for each type of printer. When I gets installed, it gets installed as printer.setup. I was trying to install the Laserwriter after installing the Imagewriter, and it replaced the printer.setup file that was installed for the Imagewriter printer. Does it matter? Does it make any difference when printing alternatively between the Imagewriter and the LaserWriter (well, actually, printing to a Postscript file on disk) which *.setup file gets installed by the installer? Thanks, Ray Ray Rankins |(518) 387-7174 | INTERNET: rankins@argentina.crd.ge.com 2 Moonglow Rd. |(518) 583-3320 | COMPUSERVE: 71131,3236 Gansevoort, NY 12831 | | AmericaOnline: RayRankins | GEnie: R.Rankins