Path: utzoo!attcan!uunet!bellcore!att!linac!pacific.mps.ohio-state.edu!zaphod.mps.ohio-state.edu!wuarchive!udel!rochester!pt.cs.cmu.edu!o.gp.cs.cmu.edu!andrew.cmu.edu!rg2c+
From: rg2c+@andrew.cmu.edu (Robert Nelson Gasch)
Newsgroups: comp.sys.mac.programmer
Subject: Think C Debugger
Message-ID: <kbEKjAy00WBKA0ZKUE@andrew.cmu.edu>
Date: 14 Nov 90 16:07:40 GMT
Organization: Class of '91, Carnegie Mellon, Pittsburgh, PA
Lines: 11

This is probably incredibly stupid, but I havn't been able to figure
it out yet and it's really annoying:
I'm using Think C 3.0 and have 7 files with (my) code in the project.
When I choose 'use debugger', I can only use it on 3 of the files,
the other four are not marked by the little 'diamond'. The manual
doesn't really say anything about this and I havn't been able to
figure it out. How do I get the other files to be recognized
by the debugger?

Any suggestions would be greatly welcome
--> Rob