Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!hellgate.utah.edu!caen!zaphod.mps.ohio-state.edu!mips!daver!bungi.com!news From: george@wombat.bungi.COM (George Scolaro) Newsgroups: comp.sys.nsc.32k Subject: Re: ETH532 status? Message-ID: <9011160845.AA16099@wombat.bungi.COM> Date: 16 Nov 90 15:45:28 GMT Sender: news@daver.bungi.com Lines: 41 Approved: news@daver.bungi.com [In the message entitled "ETH532 status?" on Nov 16, 15:32, Jordan K. Hubbard writes:] > > Hi, > > I seem to recall that the ETH532 board was finished and that several > boards had been produced. Has anyone (besides Dave and George) ordered > one and gotten it working? No wrong, unfortunately. The design is done and the board routed, but no PCB has been made as of yet. We haven't done a run since the number of people indicating they were serious about one was pretty small (less than 5), so we have been waiting for more people. A run of 5 - 10 boards would come to around $350 a piece - too rich! We would like to do a minimum of 20 (to lower the NRE - i.e. setup and test fixture charges). So, if any of you serious want it now and would commit to one or more then send me email "direct" and I will tally you up. Of course being close to xmas means a lot of us wont be up to our eyes in cash :-( Just to remind you what the ET532 is: Plug in card for the PC532 with SCSI connector in addition to edge connector. This means it could be used with other SCSI systems, it also has a standalone power connector (PC floppy/harddisk style). 32GX32-20 CPU (no FPU). 1 or 4 Megabytes of DRAM utilizing fast page mode (similar to PC532), but using DIPs. 1 Boot EPROM 1 Ethernet interface, both Cheapernet (10BASE2) and Thick (10Base5). 2 8 Channel Octarts - 16 serial channels. Requires daughterboard for RS232 drivers. These channels have full modem control (as per PC532). DP8490 SCSI interface to header and edge connector. With a 32532 instead of the 32GX32 this board could also run Minix... A cheaper PC532... best regards, -- George Scolaro george@wombat.bungi.com [37 20 51 N / 122 03 07 W]