Path: utzoo!utgpu!news-server.csri.toronto.edu!rutgers!gatech!ncar!zaphod.mps.ohio-state.edu!usc!jarthur!uunet!orca.dsd.es.com!javelin.es.com!pashdown From: pashdown@javelin.es.com (Pete Ashdown) Newsgroups: comp.sys.amiga Subject: Re: amax ii interlace question Message-ID: <1990Nov21.161158.6008@javelin.es.com> Date: 21 Nov 90 16:11:58 GMT References: <1990Nov18.190039.1231@cunixf.cc.columbia.edu> <90323.224513JKT100@psuvm.psu.edu> Distribution: usa Organization: Evans & Sutherland Computer Corp., Salt Lake City, Utah Lines: 23 JKT100@psuvm.psu.edu (JKT) writes: >By the way: I've been actively seeking a way to make the mouse >start up in fastest mode so you don't have to set it each time. >No luck so far. I tried to get a Mac programmer to write such an >INIT, but he was unable to figure out how the speed value was stored. >I tried the Mouse2 Control Panel program (it's essentially a mouse >accelerator; makes the pointer FLY on my Mac II at work) but A-Max >just ignores it; it doesn't even show up in the control panel. >If I stumble across anything, I'll post it immediately. I've got a utility that was written by a Mac user who's battery for his PRAM died. It loads the PRAM (where the control panel settings are stored) off of disk upon bootup. If there is enough interest, I could either ftp it somewhere or post it to the net BinHex'd. Its a rather tiny utility. >|| jkt100@psuvm.bitnet jkt100%psuvm.bitnet@psuvax1 QLink: KurtTappe || -- / (Rotate head 90 degrees for full effect) | BUNGEEEEEEEE! |---------------------------------------------------------------------->=