Path: utzoo!utgpu!watserv1!watmath!att!att!linac!pacific.mps.ohio-state.edu!zaphod.mps.ohio-state.edu!sol.ctr.columbia.edu!emory!hubcap!ncrcae!ncr-sd!sagpd1!monty
From: monty@sagpd1.UUCP (Monty Saine)
Newsgroups: comp.sys.amiga.hardware
Subject: Re: A1000 Internal mem hack questions.
Message-ID: <951@sagpd1.UUCP>
Date: 19 Nov 90 16:20:58 GMT
References: <1990Nov16.154751.42580@cc.usu.edu>
Reply-To: monty@sagpd1.UUCP (Monty Saine)
Organization: Scientific Atlanta, Government Products Div, San Diego, CA
Lines: 22

In article <1990Nov16.154751.42580@cc.usu.edu> miles@cc.usu.edu (Miles Johnson) writes:
>   1) Dave said:
>>	Now you'll be dealing exclusively with the daughter board.  The
>>daughter board I speak of is a 4-layer PCB labeled REV 3 on the back, up
>
>      My daughter board was REV A.  Am I dead in the water?  Or just dead
>      in the brain...
>
>   2) Dave said:
>>Next, find the 74F02 chip, called U5M on the PCB.  This chip is up 1 and
>>slightly to the left of the DPALEN PAL.  **Cut pins 10, 11, and 12** away
>>and up from the PCB as before.                      ^^  ^^      ^^

	This is an error: it should be pins 11,12, and 13 !!!!!
	I'll send you a corrected set of directions and a schematic if you
	would like. There was one other error having to do with
	" 'F10 at pin 13", but I can't remember right now what it was.


	Monty Saine
	(619) 679-6256	(days/work)
	(619) 272-7468	(eves/home)