Path: utzoo!utgpu!news-server.csri.toronto.edu!rutgers!att!emory!utkcs2!andrew
From: andrew@cs.utk.edu (Andrew Krzywdzinski)
Newsgroups: comp.sys.atari.st
Subject: Re: UniTerm 2.0e dialer question
Message-ID: <1990Nov25.022157.28576@cs.utk.edu>
Date: 25 Nov 90 02:21:57 GMT
References: <2961@gmuvax2.gmu.edu>
Sender: news@cs.utk.edu (USENET News System)
Distribution: na
Organization: University of Tennessee, Knoxville - CS Department
Lines: 14

In article <2961@gmuvax2.gmu.edu> scoile@gmuvax2.gmu.edu (Steve Coile) writes:
>
>   Lately I've been trying to use Uniterm's dialer, and I'm having some
>problems.  I'll have it dial one number, and if it doesn't connect, and
>I hang-up, I can't change the number I want to dial.  In fact, I can't
>do ANYTHING (except to get it to dial again, and hang-up).  I tried
>pressing <CTRL/C> as it says in the manual, but it doens't do anything.

I had those problems, too. It seems that if you keep pressing <ctrl>c,
it will eventually get out of dialing mode. Another option is to leave most
of the dialer setup options blank (retries, timeout, fail messages, etc.).

Hope this helps some.
-andrew krzywdzinski