Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!helios!bcm!dimacs.rutgers.edu!mips!cs.uoregon.edu!ogicse!emory!hubcap!ncrcae!ncr-sd!simasd!simasd!pnet07!donm
From: donm@pnet07.cts.com (Don Maslin)
Newsgroups: comp.sys.ibm.pc.hardware
Subject: Re: Locating drive select jumpers on MAXTOR XT1105
Message-ID: <1990Nov17.184503.8313@simasd.uucp>
Date: 17 Nov 90 18:45:03 GMT
Sender: pnet@simasd.uucp (People-NET)
Organization: People-Net [pnet07], San Diego, CA
Lines: 29

The following should help in making the correct Drive Select on the
MaxTor XT1105 (or any of the XT1000 series) drive(s).  There is a 6 pin
header on the circuit that looks something like this:
 
                      4 C 3 2 C 1
                     -------------
                    | o o o o o o |
                     -------------
                      1 2 3 4 5 6
 
Note that only one of the schemes for numbering the pins will be used -
not both!  Selection is made per the table below:
 
      BOARD LABEL      |    4C32C1      |     123456
   ---------------------------------------------------------
       Function        |  Pin Numbers   |   Pin Numbers
   ---------------------------------------------------------
      Drive Select 0   |      1.C       |       5.6
      Drive Select 1   |      2.C       |       4.5
      Drive Select 2   |      3.C       |       2.3
      Drive Select 3   |      4.C       |       1.2
   ---------------------------------------------------------
 
Good luck.
 

Keeper of the CP/M System Disk | UUCP: {nosc ucsd crash ncr-sd}!pnet07!donm
Archives for the Dino(saur)SIG | ARPA: simasd!pnet07!donm@nosc.mil
- San Diego Computer Society - | INET: donm@pnet07.cts.com