Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!swrinde!zaphod.mps.ohio-state.edu!think.com!mintaka!bloom-beacon!daemon
From: cabruen@athena.mit.edu (Charles Alan Bruen)
Newsgroups: comp.sys.mac.apps
Subject: Claris Cad
Message-ID: <1990Nov21.085359.7841@athena.mit.edu>
Date: 21 Nov 90 08:53:59 GMT
Sender: daemon@athena.mit.edu (Mr Background)
Distribution: na
Organization: Massachusetts Institute of Technology
Lines: 12


I am having a problem with the snap to grid feature on claris cad.
It does not seem to snap to grid lines that are right at whole
inch crossings. I will point the mouse right at grid point, but it
will start somewhere else. (usually a 1/4" off). This problem is not 
caused by guide mode either, because I have turned that off.
I have not found the solution in any of the manuals either. THanks for
your help.


-Charles Alan Bruen
 cabruen@athena.mit.edu