Path: utzoo!utgpu!watserv1!watmath!att!att!linac!pacific.mps.ohio-state.edu!zaphod.mps.ohio-state.edu!julius.cs.uiuc.edu!psuvax1!rutgers!gatech!ncar!boulder!frechett
From: frechett@boulder.Colorado.EDU (-=Runaway Daemon=-)
Newsgroups: comp.terminals
Subject: Re: CIT 101
Message-ID: <29944@boulder.Colorado.EDU>
Date: 18 Nov 90 06:05:08 GMT
References: <29840@boulder.Colorado.EDU> <14491@smoke.brl.mil>
Sender: news@boulder.Colorado.EDU
Reply-To: frechett@snoopy.Colorado.EDU (-=Runaway Daemon=-)
Organization: University of Colorado, Boulder
Lines: 27
Nntp-Posting-Host: snoopy.colorado.edu

In article <14491@smoke.brl.mil> gwyn@smoke.brl.mil (Doug Gwyn) writes:
-)In article <29840@boulder.Colorado.EDU> frechett@snoopy.Colorado.EDU (-=Runaway Daemon=-) writes:
-)>CHECKSUM ERROR ON NVR OO
-)
-)NVR is Non-Volatile RAM, and is where the set-up settings are stored.
-)It is typically backed up by a rechargeable battery, which can quit
-)retaining a charge after a few years (and should then be replaced).
-)Whenever you save set-up options it should also store a correct new
-)checksum.  In a case of desperation try resetting to factory default
-)(there is some simple way to do that but I don't have the manual).

Thank you very much.. A couple things though.. Where the hell is that little
battery?  I had no idea that it had this. And I would LOVE to be able to store
settings.  Would you believe that I redo my setting everytime I turn the
terminal on.. I had no idea that they could be saved.  I got the terminal
second hand without any form of documentation whatsoever.  It is a nice term
and I would like to figure out what I can do about this problem.. I could
use some help from anyone that might have a manual for this term and can 
tell me how to 
save settings
reset settings to factory's
and tell me where the batter is.. I have been running with the top off for
quite a while and I don't see anything that looks like a battery.. hmmm

	ian
--
-=Runaway Daemon=-