Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!wuarchive!zaphod.mps.ohio-state.edu!uakari.primate.wisc.edu!uflorida!gatech!ncsuvx!news From: jumper@hobbes.ncsu.edu (Michael Lanham) Newsgroups: comp.sys.ibm.ps2.hardware Subject: Re: Memory boards for MCA bus Keywords: memory, MCA Message-ID: <1990Nov25.234751.686@ncsuvx.ncsu.edu> Date: 25 Nov 90 23:47:51 GMT References: <1694@beguine.UUCP> Sender: news@ncsuvx.ncsu.edu (USENET News System) Organization: NCSU Computing Center Lines: 26 uchuck@pelham.med.unc.edu (Charles Bennett) writes: >I found what I think is the best value in expansion boards for PS/2's. It >is the TECMAR MicroRam AD. It uses 1Mb SIMMS (in pairs, so one must add >2Mb at a time), goes to 8Mb max, and here's the good part - it has a >daughter board that gives one either 2 additional serial ports OR 1 serial >and 1 parallel port. I purchased the bare board for $268 and the daughter >board for $156 and added 8Mb of SIMMS at $47/Mb. I use it in a PS/2 55SX, >but it is just as good for 50's, 60's, 70's and 80's. The part number for >the board with NO memory is 813251 and the daughter board (no additional >slot taken) is the SS/SP Module part number is 813248. I purchased them >from Hall-Mark Electronics. They have an 800 number which I don't have >handy --- take that back the 800 number is for NC. There may be others, >check 800-555-1212. I bought SIMMS from another source. >Chuck Bennett Hate to burst somebody's bubble, but.... The model 70 and up in the PS2 line all have 32 bit memory slots. therefor the cards for the 50, 55sx, 60 cannot be used in the 70 or 80, nor can the 32 bit memory card for th 70 & 80 fit in the 50, 55sx,60. -- He who will not reason, is a bigot; he who cannot is a fool; and he who dares not is a slave. --- Sir William Drummond Michael Lanham mjlanham@eos.ncsu.edu & jumper@.catt.ncsu.edu