Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!sdd.hp.com!zaphod.mps.ohio-state.edu!tut.cis.ohio-state.edu!purdue!haven!decuac!shlump.nac.dec.com!jareth.enet.dec.com!edp
From: edp@jareth.enet.dec.com (Eric Postpischil (Always mount a scratch monkey.))
Newsgroups: comp.sys.handhelds
Subject: Re: HP48 matrix entry problem.
Message-ID: <17781@shlump.nac.dec.com>
Date: 4 Dec 90 13:48:06 GMT
References: <90337.150401ERSHC@CUNYVM.BITNET>
Sender: newsdaemon@shlump.nac.dec.com
Reply-To: edp@jareth.enet.dec.com (Eric Postpischil (Always mount a scratch monkey.))
Organization: Digital Equipment Corporation
Lines: 14

In article <90337.150401ERSHC@CUNYVM.BITNET>, ERSHC@CUNYVM writes:

>For some reason, when in Matrix entry mode, my rev.D hp48sx is NOT
>advancing to the next cell after entering a number. Also, I
>can't enter more than 1 number at a time. If I try (into a (- x 2) matrix)
>1 <spc> 2 <enter> I get 1 0, which is quickly overwriten with 2 0.
>Anyone have any idea whats going on?

Check the Owner's Manual on page 351, in the MatrixWriter section.   There are
two menu keys in the MatrixWriter that say "GO" with an arrow after them; they
control where the cursor goes after entering a number.


				-- edp