Path: utzoo!utgpu!news-server.csri.toronto.edu!rutgers!apple!vsi1!daver!bungi.com!news
Newsgroups: comp.sys.nsc.32k
Subject: Re:  PC532 Expansion & other questions
Message-ID: <9011301813.AA18126@manatee.UUCP>
Date: 30 Nov 90 23:13:03 GMT
References: <<9011300212.AA05577@virtech.UUCP>>
Sender: news@daver.bungi.com
Lines: 19
Approved: news@daver.bungi.com


> > My board arrived.  Currently I'm pouring over the schematics before turning
> 
> Pouring over them?  By the way, would flux remover help?  I tried using
> alcohol with little success.  But the board seems to run fine anyway.
> Any recommendations?

If you promise not to harass me, giggle, or whatever I will tell you 
what I used..  Well anyway, I found some automotive "Wax and Grease 
Remover" in the garage -- you know, the stuff you use to prep a car 
before you repaint it..  Just scrubbed it down using an old tooth brush
and then washed it off with ivory liquid soap.  To dry it I used
a hair dryer.  Works great provided you are careful to not let the 
petroleum distillate run to the top side of the board and get under 
the components. 

-- 
John Connin: manatee Orlando, Florida
         UUCP: {uunet,ge-dab,ucf-cs}!tarpit!tous!manatee!johnc