Path: utzoo!censor!geac!torsqnt!news-server.csri.toronto.edu!cs.utexas.edu!wuarchive!bcm!dimacs.rutgers.edu!dorm.rutgers.edu!medici From: medici@dorm.rutgers.edu (Mark Medici) Newsgroups: comp.windows.ms Subject: Re: Token Ring & Win 3.0 Message-ID: Date: 3 Dec 90 19:08:09 GMT References: Organization: Rutgers Univ., New Brunswick, N.J. Lines: 69 et10+@andrew.cmu.edu (Edmund E. Tsai) writes: >Has anyone been able to get a Token Ring Adapter to work with Windows? Yes. I'm using WinQVT/Net under MS-Windows 3 with an IBM Token Ring Adapter II/a. I am currently attached to four NetWare servers (286 and 386) and have telnet sessions to two UNIX hosts. >I looked at the clarkson drivers and there is a driver for the token >ring but it says I need to have the IBM LAN software loaded. Anybody >know how much this software costs? The IBM PC LAN Support Program version 1.1 (IBM feature # 5683) lists for $60.00. If you have a volume purchase agreement or are an educational inst. you can get it for $40.00. Note that version 1.2 is actually the current version of this software. I don't have any price information but would expect version 1.2 is roughly equal to version 1.1 in cost. >Also, why is it that when I run TOKREUI.COM and then run Windows 3.0, >Windows crashes? Don't know. >I can get the token ring to work if I load TOKREUI.COM in a DOS session >under windows but after some time I usually get a SYSTEM INTEGRITY >CORRUPTED message. The configuration I have is: CONFIG.SYS device=c:\bin\HIMEM.SYS ;Microsoft high memory driver device=c:\bin\SMARTDRV.SYS 2048 512 ;Microsoft disk cache device=c:\bin\DXMA0MOD.SYS ;IBM PC LAN Support program device=c:\bin\DXMC0MOD.SYS ,d800 ; " specifies address d800 device=c:\bin\ANSI.SYS ; lastdrive=k ;Makes L: first network drive buffers=10 ;Few buffers because of cache files=30 ;Depends on applications stacks=0,0 ;Save a little RAM shell=c:\COMMAND.COM /e:1024 /p ;Big environment AUTOEXEC.BAT [bunch of stuff to setup environment -- none useful to you] IBMTOKEN.COM 0x61 0 ;Packet driver for Token Ring c:\win\winqvt\PKTINT.COM ;WinQVT/Net packet drv interface IPX.COM ;NetWare IPX protocol driver XMSNET3.EXE ;NetWare DOS redirector shell L: ; LOGIN ;Login on server C: CD C:\WIN WIN ;Start MS-Windows C: CD \ If you are using a NetBios LAN (e.g., IBM PC LAN Program), you will have to add DXMT0MOD.SYS with the requisite configuration options to your CONFIG.SYS, and replace IPX and XMSNET3 with NET START and NET USE commands (as appropriate for your LAN software). Hope this helps. Good luck. -- ---------------------------------------------------------------------------- Mark Medici/SysProg3 * Rutgers University/CCIS * medici@elbereth.rutgers.edu ----------------------------------------------------------------------------