Path: utzoo!utgpu!news-server.csri.toronto.edu!rutgers!ucsd!mvb.saic.com!ncr-sd!simasd!simasd!pnet07!donm
From: donm@pnet07.cts.com (Don Maslin)
Newsgroups: comp.os.cpm
Subject: Re: Reply to Big Board II
Message-ID: <1990Dec9.072504.12658@simasd.uucp>
Date: 9 Dec 90 07:25:04 GMT
Sender: pnet@simasd.uucp (People-NET)
Organization: People-Net [pnet07], San Diego, CA
Lines: 29

fzsitvay@techbook.com (Frank Zsitvay) writes:
> 
>  now, i know the hardware of an AT floppy controller will be able to control
>an 8 inch drive.  that is understood without question, since it is basically
>the same as the interface used with 8 inch drives.
> 
>  what i meant to ask was, "Does uniform know how to use the AT floppy
>controller when it is connected to an 8 inch drive??"
> 
It is necessary for UniForm to be 'advised' of the presence of a particular
drive in order for it to access it.  This is done in the AT's CMOS and/or in
the config.sys file - depending on the controller, etc.  In the case of
CompatiCard, there is the statement: device = ccdriver (followed by
appropriate hyroglyphics) that identifies the drive parameters.  It may well
be possible to accomplish the same thing using whatever driver your
HDC/FDC uses to identify attached floppies.  But, not having tried it, I don't
know for sure.  Hopefully some other reader does, and will share his wisdom
with us.
> 
>   i know a compaticard would solve the problem, but in my situation that
>is not an alternative.
>
That is understood and appreciated.

                                                - don

Keeper of the CP/M System Disk | UUCP: {nosc ucsd crash ncr-sd}!pnet07!donm
Archives for the Dino(saur)SIG | ARPA: simasd!pnet07!donm@nosc.mil
- San Diego Computer Society - | INET: donm@pnet07.cts.com