Xref: utzoo comp.dcom.lans:6745 comp.sys.mac.comm:1889
Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!sdd.hp.com!wuarchive!udel!princeton!njin!uupsi!intercon!news
From: kdb@macaw.intercon.com (Kurt Baumann)
Newsgroups: comp.dcom.lans,comp.sys.mac.comm
Subject: Re: Ethernet Connection for Mac
Message-ID: <2766A0E7.10D9@intercon.com>
Date: 12 Dec 90 21:28:07 GMT
References: <1990Nov27.190351.5666@ux1.cso.uiuc.edu> <1990Dec12.021251.3808@portia.Stanford.EDU>
Sender: usenet@intercon.com (USENET The Magnificent)
Reply-To: kdb@macaw.intercon.com (Kurt Baumann)
Organization: InterCon Systems Corporation, Herndon, VA
Lines: 19

In article <1990Dec12.021251.3808@portia.Stanford.EDU>,
zhao@elaine19.stanford.edu (tiemin zhao) writes:
> I've seen people using a Mac on the Ethernet while connected to a
> LocalTalk network at the same time. But I don't know what it takes to
> have that setup. Could anyone give me some suggestions?

Depends on what software you are using over the Enet.  As an example, if
you were using NCSA telnet or TCP/Connect II, you set which net (port) they
are using internally not through the control panel.  So you leave the control
panel alone (on appletalk) and either in the configuration file or on the
configuration screen of the TCP/IP package you pick the Enet card.  Then
you have no problem.

Hope that helps.

--
Kurt Baumann                       InterCon Systems Corporation
703.709.9890                      Creators of fine TCP/IP products
703.709.9896 FAX               for the Macintosh.