Path: utzoo!attcan!uunet!munnari.oz.au!mtiame!jep From: jep@mtiame.mtia.oz (Jesper Peterson) Newsgroups: comp.sys.amiga.tech Subject: Re: Handshake wont work with 2400zi! Message-ID: <1990Dec12.031552.18139@mtiame.mtia.oz> Date: 12 Dec 90 03:15:52 GMT References: <1990Dec5.082032.26103@maverick.ksu.ksu.edu> Organization: Metal Trades Industry Association, Victoria, Australia. Lines: 22 In article scot@amigash.UUCP (Scot L. Harris) writes: > The only >compatibility type problem I have with serial ports is with the JX-100 >ScanLab software. It insists on banging on the default port before hitting >the internal port directly. As a result I have to set the default port back >to unit 1 before I use the JX-100. I had hoped that ASDG could provide me >with a patch or update or something that would let the ScanLab software either >pick the unit number it is to use or at least make it look for unit 1 instead >of unit 0 (the default port). This brings up another interesting question: Does the Scanlab software know about ASDG's Dual serial port board? I have Scanlab and the JX-100 but I've seen no explicit mention of it in the manual (probably because I haven't read it). Would it recognise the the "amiga serial port" on the board and operate it at full speed without problems? Jesper. -- ------------------------------------------------------------------------------ USEnet: jep@mtiame.mtia.oz.au UUCP: ...!uunet!munnari!mtiame.oz!jep [...] I had to leave out reality to keep the post clean and to the point. - jeremy@milton.u.washington.edu (Jeremy York) in rec.music.misc