Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!sdd.hp.com!zaphod.mps.ohio-state.edu!sol.ctr.columbia.edu!emory!hubcap!ncrcae!ncrlnk!ncrcam!mreiss
From: mreiss@ncrcam.Cambridge.NCR.COM (mreiss)
Newsgroups: comp.sys.atari.st.tech
Subject: Uniterm (RS232CONF function)
Summary: Need info on paramater string
Keywords: Uniterm, RS232 configuration
Message-ID: <2221@ncrcam.Cambridge.NCR.COM>
Date: 10 Dec 90 14:54:31 GMT
Reply-To: mreiss@ncrcam.Cambridge.NCR.COM ()
Organization: NCR, E&M Cambridge, Ohio
Lines: 26


I have several macros that og me into several different systems.  Until
last week everythinig was great.  Then I had to get into a system that
has a different baud rate and number of data bits.  Well I have been making
those changes manually as I change between systems.  I want to include those
in my login macros.  According to the documentation that I have, the function
that I want to use is RS232CONF.  So far so good.  DOCs say to see dialer
setup for description of the configuration string to supply to RS232CONF.
O.K. I found that.  The two strings that I want appear to be 10001 and 20101.
But I cannot get Uniterm to accept these. I have tried several different 
formats as follows:

rs232conf(10001)
rs232conf('10001')
rs232conf('/10001')
rs232conf(/ 10001)
rs232conf('/ 10001')

None of these do anything except abort the macro processor.  Can someone tell
me the correct format that will make my life a whole lot easier?  I hope so.

mike
-- 
Michael A. Reiss				|
						|	mike
USENET = Mike.Reiss@Cambridge.NCR.COM		|