Xref: utzoo comp.periphs.scsi:1507 comp.sys.dec:4692
Path: utzoo!utgpu!news-server.csri.toronto.edu!cs.utexas.edu!swrinde!zaphod.mps.ohio-state.edu!uakari.primate.wisc.edu!dali.cs.montana.edu!masscomp!westford.ccur.com!rtc
From: rtc@westford.ccur.com (Robert Chesler)
Newsgroups: comp.periphs.scsi,comp.sys.dec
Subject: Emulex ROMS for Qbus SCSI controller, or formatter floppy
Keywords: I'm stuck - old rev SC04
Message-ID: <61524@masscomp.ccur.com>
Date: 10 Dec 90 20:28:22 GMT
Sender: news@masscomp.ccur.com
Reply-To: rtc@westford.ccur.com
Followup-To: comp.periphs.scsi
Organization: Concurrent Computer Corporation
Lines: 19


A while back I purchased a used Emulex SC04 Qbus SCSI controller.
I tried it with my Adaptec 4000 and an ST506 winchester disk.  I couldn't
see the disk through the operating system (ULTRIX), however I see the 
controller just fine.

I figured if I got a native SCSI disk I might be all set, so I purchased
a used MAC SCSI disk, and that too could not be seen.

Does anyone have the formatter/diagnostic floppy for an SC04 that I could
borrow or purchase to see if the device is working?  Alternatively,
does anyone have a spare ROM set, perhaps from a broken SC04 board,
that includes the formatter, or is at least a recent revision?

Any suggestions?  So far the only suggestion was from Emulex, and that was
to spend $300 for a ROM upgrade or $300 for the floppy, or $1000 for their
latest SCSI board.

--Robert