Path: utzoo!attcan!uunet!panews.awdpa.ibm.com!ibmpa.awdpa.ibm.com!marc From: marc@ibmpa.awdpa.ibm.com (Marc Pawliger) Newsgroups: comp.unix.aix Subject: Re: Load maps? Message-ID: <1990Dec10.095540@ibmpa.awdpa.ibm.com> Date: 10 Dec 90 17:55:40 GMT References: Sender: news@panews (news id) Reply-To: marc@ibmpa.awdpa.ibm.com (Marc Pawliger) Distribution: na Organization: IBM Advanced Workstations Division, Palo Alto Lines: 21 In article , hudgens@sun13.SCRI.FSU.EDU (Jim Hudgens) writes: |> |> Does anyone know how to get the Fortran compiler to generate a load |> map? It is not entirely clear what compiler flags need to be set. |> I tried several combinations (-Wl,-M as I recall) but that did not |> appear to do anything useful. Anyone done this??? I am assuming (since you didn't say) that you are running on the Risc System/6000. It is a sad fact that being called "comp.unix.aix" does not address that fact that there are at least 4 flavors of AIX in the world (AIX/RT, AIX/PS/2, AIX/370 and AIX/6000) Well, for the C compiler, the flag is "-bloadmap:load.map", and the loadmap will be in the file "load.map". I believe (I don't have Fortran docs readily available) that this flag is just passed on the loader, which is the same for Fortran and C, so the same flag should work for Fortran. +---Marc Pawliger---IBM Advanced Workstations Division---Palo Alto, CA---+ | Internet: marc@ibminet.awdpa.ibm.com VNET: MARCP at AUSVM6 | | UUCP: uunet!ibmsupt!ibmpa!marc Phone: (415) 855-3493 | +------IBMinet: marc@ibmpa.awdpa.ibm.com------IBM T/L: 465-3493--------+