Path: utzoo!attcan!uunet!munnari.oz.au!uokmax!apple!usc!zaphod.mps.ohio-state.edu!pacific.mps.ohio-state.edu!linac!att!att!fang!alfred!tous!tarpit!bilver!bill
From: bill@bilver.uucp (Bill Vermillion)
Newsgroups: comp.unix.xenix.sco
Subject: Re: IRQ 2 with WD8003
Message-ID: <1990Dec8.171200.1936@bilver.uucp>
Date: 8 Dec 90 17:12:00 GMT
References: <1990Dec4.184039.6358@buchonia.rhoen.in-berlin.de> <TF2L3KD@geminix.in-berlin.de>
Reply-To: bill@bilver.UUCP (Bill Vermillion)
Distribution: comp
Organization: W. J. Vermillion - Winter Park, FL
Lines: 16

In article <TF2L3KD@geminix.in-berlin.de> gemini@geminix.in-berlin.de (Uwe Doering) writes:
>horke@buchonia.rhoen.in-berlin.de (Bernhard Kroenung) writes:
>
>>My system is an 386 with 387 at 25Mhz 8Mb (Chicony Board) and Xenix 2.3.3
....
>>I wanted to add an WD8003 with IRQ 2 and Base-Adress 0x280 or 0x300 or
 
>I tried to use the WD8003 card on IRQ2, too, but under 386/ix this

IRQ2 is cascaded to IRQ9 on the AT bus.  You can't get to IRQ2.  That
explains your problem.


-- 
Bill Vermillion - UUCP: uunet!tarpit!bilver!bill
                      : bill@bilver.UUCP